GBP (£)
DPA d:dicate™ 4006C Stereo Pair with Clips and Windscreens in Peli Case
The wide and versatile d:dicate™ Microphone series is legendary in the high-end recording and film production industry. Delivering clean, accurate sound, the mics in this series are used by professionals, who understand sound and insist on only using the best.
We have collected our award-winning d:dicate™ Recording Microphones in specialized stereo pairs that are matched within either ±0.5 dB, ±1 dB ±1.5 dB, depending on the pair you choose. Explore the stereo pairs below.
ST4006C Stereo Pair
This kit is similar to the ST4006A Stereo Pair, using the same MMC4006 Omnidirectional Microphone Capsule to gain its amazing sound. Whenever a small, lightweight, inconspicuous microphone for top-quality recording is required, a d:dicate™ 4006C Omnidirectional Microphone is the right choice. They come as a hand-matched pair that offers the truest capture of stereo sound available.
- Modularity – interchangable capsules and preamplifiers
- Up to 120 dB dynamic range
- RF rejection between >60 and >40 dB
- Linear frequency response
- High SPL
- Superior gain before feedback
| Total harmonic distortion (THD) | < 1 % up to 134 dB SPL peak | Matching tolerance | ± 0,5 dB |
|---|---|---|---|
| Output voltage, RMS | > 4 V | Power supply (for full specifications) | 48 V Phantom power (± 4 V) |
| Sensitivity, nominal ±2 dB at 1 kHz | 40 mV/Pa; -28 dB re. 1 V/Pa | Frequency range, ± 2 dB | 20 Hz to 20 kHz |
| Catridge type | Pre-polarized condenser | Phase deviation for kit | < 5° |
| Equivalent noise level, ITU-R BS.468-4 | Typ. 27 dB (max. 29 dB) | Relative humidity (RH) | Up to 90% |
| Capsule diameter | 16 mm (0.63 in) | Common mode rejection ratio (CMRR) | > 50 dB |
| Output balance principle | Impedance balancing with Active Drive | Cable drive capability | 100 m (328 ft) |
| Minimum load impedance | 2 kohm | Max. SPL, peak before clipping | 140 dB |
| Weight | 63 g (2.2 oz) | S/N ratio (A-weighted), re. 1 kHz at 1 Pa (94 dB SPL) | Typ. 79 dB(A) |
| Equivalent noise level, A-weighted | Typ. 15 dB(A) re. 20 µPa (max. 17 dB(A)) | Principle of operation | Pressure |
| Directional pattern | Omnidirectional | Polarity | +V at Pin 2 for positive sound pressure |
| Temperature Range | -40 °C to 45 °C (14 °F to 113 °F) | Current Consumption | 2.8 mA |
| Diameter | 16 to 19 mm (0.63 to 0.75 in) | Connector | XLR-3M. Pin 1: shield, Pin 2: signal + phase, Pin: - phase |
| Length | 64 mm (2.5 in) | Frequency Range | 10 Hz to 20 kHz |
| Output Impedance | < 200 ohm | Dynamic Range | Typ. 119 dB |
| Color | Matte black |
